|
| Vases |
|
Salt vase (1107-004)
$72.00
The color variation on this large salt glazed vase results from my spraying it with salt slips when it is still leather hard. I then raw glaze the inside, let it dry, and apply salt-resistant wadding. 12" tall x 3" wide.
|
Two-part ikebana vase (0709-002)
$58.00
The texture on the top of this two-part ikebana vase reminds me of underwater sand patterns. It's made by undercutting with a wiggle wire. 3"x 7.5"
|
Salt glazed vase (1208-026)
$66.00
The light bright color range on this salt glazed vase derives in part from the fact that it's made of a mixture of stoneware and porcelain clays. 12" x 5"
|
Faceted salt glazed vase (0709-004)
$48.00
The texture on this faceted vase was made by a wiggle wire. The vase ranges in color from warm brown to soft blue. 8"x6"
|
Ikebana vase (0709-018)
$36.00
I've been playing with some new wiggle wires, as is evidenced by the top of this ikebana vase. The wire's wide deep cuts create a surface texture that reminds me of patterns left in sand by moving water. 2.5"x5"5"
|
Salt glazed ikebana vase (1208-005)
$36.00
1208-005
This ikebana vase has a stainless steel pin frog epoxied in the base. These pots are made upside down, so the top edge is formed by the cut-off wire against the wheel-head. 2" x 5"
|
Stoneware ikebana vase (1208-006)
$36.00
1208-006
I put a dark blue glaze on the top of this vase, then sponged it back off, so it only stayed in the grooves created by my cut-off wire, before glazing the whole pot in a celadon. Contains a stainless steel pin frog. 2" x 4.5"
|
Oval vase (1208-009)
$52.00
1208-009
I've been having fun recently playing with a wiggle wire. The wire, marketed by Bill van Gilder, makes a variety of marks. On this vase, I pulled down through the wall with the wheel turning slowly. I later pushed the wall into an oval and added a base. 3" x 4" x 8"
|
Two-part ikebana vase (0709-003)
$58.00
This orange color of this two-part ikebana vase derives from the flashing slip I brushed onto it. The textured top comes from undercutting it with a wiggle wire. 3"x7.5"
|
|
|
|